Electrical equipment is made according to a single-wire circuit: the negative terminals of sources and consumers of electricity are connected to the "ground" - the body and the power unit of the car, which act as a second wire
We remove the driven and driving disk when replacing, as well as when replacing the rear crankshaft oil seal and when replacing the flywheel
The need to remove the steering column occurs due to a malfunction of the column shaft bearings or intermediate shaft universal joints
The ABS system includes wheel speed sensors and a valve body.
We usually remove speed sensors for inspection or replacement, as well as when dismantling units
We remove the gearbox for replacement or repair, as well as for repairing the clutch, removing the engine and replacing the primary bearing of the gearbox.
The wheel (working) cylinder of the rear wheel brake mechanism is replaced when the braking efficiency of the wheel decreases due to jamming of the pistons in the cylinder or leakage of brake fluid through the cylinder seals
It is advisable to check the oil level in the engine sump daily before a trip or during a long trip every 300-400 km