We remove the car engine together with the gearbox, lowering it down from the engine compartment
Therefore, it is advisable to install the car on a lift.
If the engine is shot in garage conditions, you need to have high supports and jacks to remove the engine from under the car, lowered to the garage floor.
For the convenience of work, you need to remove the hood
Reducing the fuel pressure for this
Disconnect the wiring block from the fuel module and, starting the engine, wait until it stalls.
Disconnect the wires from the battery and remove it from the car
Drain the coolant from the cooling system
We remove the drive belt of auxiliary units
Removing the air filter housing
Removing the engine mudguard, described in the article - Removing and installing the Hyundai Solaris engine mudguard
Removing the front wheel drives
Disconnect the wiring block from the generator
Unscrew the bolts securing the air conditioner compressor.
Without disconnecting the tubes from the compressor, we take it aside and tie it with a rope or wire.
Unscrew the nuts of the studs securing the fuel line flange to the fuel ramp flange
Disconnect the flanges
Disconnect the hoses of the engine cooling system from the nozzles on the cylinder head
We remove the clutch working cylinder without disconnecting the pipeline from it
We take the working cylinder aside and tie it
Disconnect the control cables from the gearbox
Disconnect the pads of the wiring harnesses from the terminals of the sensors of the engine control system
Disconnect the hoses from the inlet pipe fittings
Disconnect the tips of the mass wires from the engine and gearbox
We disconnect all the fasteners of the wiring harness from the brackets of the power plant
Disconnect the hose from the fitting of the adsorber purge solenoid valve
We fasten the slings of the lifting mechanism for the transport eyelets and pull the slings
Once again we check whether all wires and hoses and assemblies are disconnected from the power plant
We hang out the front part of the car (lift the car on a lift) to a height sufficient to extract the power plant.
Removing the engine from under the car
We install the power unit in reverse order.